Home page

Loco Kits in N

N Brass all loco, coach and wagon parts

GWR loco and coach fittings in N

Southern Railway loco fittings in N

LMS pre-group fittings in N

LMS fittings in N

LNER pre-group fittings in N

LNER fittings in N

BR loco fittings, general loco fittings, coach and wagon fittings.

Precursor Model Railway parts

Coach and wagon parts N Gauge

Trams, narrow gauge, posters and timetalbles in N

Line side kits, fencing and signals in N

Signal equipment and signals in N gauge

25 kV catenary supports and fittings in N

Rolling road for N gauge

Our contact details

BR, LMS, MR Johnson tender etches


L&Y ironclad 060 etches for 2mm



Diagram showing some of the tender parts included on the fret.  Not all parts shown are included.


Johnson 3250 gallon tender, a BR, LMS and Midland Railway tender.


These tenders were built in large numbers for MR engines.  Variations included water pickup apparatus and alternative coal rails.

Kit Details

This is a selection of parts for an Johnson 3250 gallon tender body.  Not all parts needed to make a tender body are on the fret, some parts will need to be scratchbuilt.  No chassis parts are included e.g. wheels, paint and transfers.  The 2mm Association produces many parts which are suitable.

This etch has been reduced from a 4mm etch.  At stages during assembly  the builder will need to use their own solutions.  The 2mm Association has publications and articles in their magazine which may be of help.  The links below go to a pdf copy of the diagrams included with the 4mm etch and to a picture of the fret with the parts identified.


These etches are slightly large for N.  The tender footplate is 1ft too long and 3in too wide.

Tender parts

Tender instructions


28745  Johnson 3250 gallon tender some body parts.  10.00.





  For MR loco parts see  LMS Parts 1

Copyright (c) 2016 N Brass Locomotives. All rights reserved.