Home page

Loco Kits in N

N Brass all loco, coach and wagon parts

GWR loco and coach fittings in N

Southern Railway loco fittings in N

LMS pre-group fittings in N

LMS fittings in N

LNER pre-group fittings in N

LNER fittings in N

BR loco fittings, general loco fittings, coach and wagon fittings.

Precursor Model Railway parts

Coach and wagon parts N Gauge

Trams, narrow gauge, posters and timetalbles in N

Line side kits, fencing and signals in N

Signal equipment and signals in N gauge

25 kV catenary supports and fittings in N

Rolling road for N gauge

Our contact details

BR, LMS, MR 3F 0-6-0 etches


L&Y ironclad 060 etches for 2mm



Diagram showing some of the loco parts included on the fret.  Not all parts shown are included.


MR 0-6-0 a BR, LMS and Midland Railway engine.


Introduced in 1916 by S. W. Johnson.  480 were built for the Midland Railway and 10 for the Somerset and Dorset.  Many passed to the LMS and BR, the last being withdrawn in 1964..

Kit Details

This is a selection of parts for an 3F loco body.  Not all parts needed to make a loco body are on the fret, some parts will need to be scratchbuilt.  No chassis parts are included e.g. wheels, motor, gears, paint and transfers.  The 2mm Association produces many parts which are suitable.

This etch has been reduced from a 4mm etch.  At stages during assembly  the builder will need to use their own solutions.  The 2mm Association has publications and articles in their magazine which may be of help.  The links below go to a pdf copy of the instructions included with the 4mm etch and to a picture of the fret with the parts identified.


These etches are slightly large for N.  The loco footplate is 1.25ft too long and 6in too wide.

3F parts

3F instructions


28744  3F some loco body parts.  10.00.





  For MR loco parts see  LMS Parts 1

Copyright (c) 2016 N Brass Locomotives. All rights reserved.